Introduction
Castle Series Rack 1KVA ~ 6KVA UPS, pure-line double-conversion
architecture, is an effective solution to the problem of the best
all power architecture. This architecture can effectively block the impact of abnormal
power to the load, while ensuring the stability of the output
power, precision, reliable, safe operation to the load. Designed specifically for rack-mounted applications, for the
protection of rack servers, storage products, network equipment
rack.
Technical parameters
Application Environment: Office | room
Input and output: a single in single out
Power: 3KVA-6KVA
Sine wave output
Both in AC mode or battery mode, can be low-distortion sine wave
output power, the load for the user equipment for the best power
protection.
Zero transfer time
When power cut or re-power, UPS and battery power mode in the city
to switch between modes is not the conversion time, effectively
ensuring the reliability of the load operation.
Enter the zero line of fire detection
Hills Rack UPS 1K ~ 3K (S) with zero FireWire reverse detection. To avoid the firing line UPS mains input zero reverse.
Bypass output humanity
To avoid the Hills user to work in BYPASS MODE UPS does not start
to use, resulting in electricity interruption, UPS and the
equipment are abnormal shutdown. Hills Rack UPS 1K ~ 3K (S) input is normal electricity, the default
no-pass output. Must be switched on, will have a normal inverter output. But can WinPower2000 Hills Software on the Web site to change the
configuration to "market power output of a bypass."
TVSS feature
TRANSIENT VOLTAGE SURGE SUPPRESS that surge voltage protection. Rack UPS has been used in FAX, TELEPHONE, MODEM, network conversion
protection.
Input power factor correction
Rack UPS with input power factor correction, the fully loaded case,
the input power factor can reach above 0.95, so that the user's
network environment is not contaminated.
DC Start
Power blackouts in the city state, if your computer need to use
Rack UPS or other loading equipment, Rack UPS directly to the DC
battery power, so that the use of Rack UPS is more convenient and
reliable.
Bypass Protection
Rack UPS bypass feature allows the emergency response capability
has been greatly enhanced, while the load devices in the user the
power of special requirements, such as the voltage is not too high,
Rack UPS bypass supply voltage is too high to provide protection to
the user's load equipment from high voltage risk.
Auto-start function
When the electricity abnormal power into battery mode until the
end, Rack UPS will shut down when the electricity back to normal,
Rack UPS will automatically start the boot and restore normal power
supply, without the user each boot.
Long-term power supply design
Rack UPS provide a comprehensive long-term drive for users to
choose. Configure the appropriate battery pack allows the user to discharge
up to 8 hours using the time to meet different network environment.
A powerful charging ability of long-term machine
Rack UPS in addition to long-term drive to extend the discharge
time, the battery recharge capacity is also very strong, about 4 ~
9A to provide the initial charge current.
Self Check
Rack UPS power situation can be simulated into the battery mode
power supply, this function either through self-test button on the
panel at any execution, or monitoring software with the Hills, by
regular or irregular manner.
Strong anti-jamming
For electromagnetic interference and radio frequency interference,
Rack UPS follow international standards EN50091-2 and IEC61000-4
series o
